Danny’s Rod Shop

1843 Old SR 28

Goshen, OH  45122

Tech/Orderline: 513-722-3522

Toll Free: 800-335-1932

Since 1982

Billet Aluminum Throttle Assemblies

Available with Rubber Insert or Ball Milled. Dimensions for Standard & XL Assemblies.

Chrome Steel Throttle Assemblies

Dimensions for Standard & XL Assemblies.

Camaro Billet Aluminum Throttle Assemblies & Brake Pads

1967-1969 Camaro Gas Pedal Assembly is designed to bolt into the stock location on the firewall allowing you to change from rod linkage to throttle cable linkage. Brake Pad Cover is machined to fit over the stock Camaro steel pad. Design is a direct fit. For manual shift, use Lokar’s clutch/brake pad for late model trucks.

Late Chevy Truck Throttle, Brake & Emergency Brake Pads

Billet Aluminum Brake Pad replaces factory rubber pad & is Quick and Easy to install. There is no drilling required & no alignment problems. Hardware included.

1955-1957 Chevy Billet Aluminum Throttle Pedal Assemblies

Lokar’s ‘55, ‘56 and ‘57 brake pads and clutch pads are designed to match the Lokar gas pedals in both ball-milled aluminum and with rubber inserts. No drilling is needed to mount pads, which allows easy installation. Designed to mount in original firewall location with offset bezel washer to align throttle cable through firewall.

Power Brake Pads

XL Non-Power Brake Pads

Chromed Steel Spoon Gas Pedal Assembly

Ball-Milled Aluminum POWER brake pad has an outside measurement of 5” x 2 3/4” & fits the 4 3/4” x 2 3/8” original steel brake pedal. For ‘55, ‘56 & ‘57.

Ball-Milled Aluminum in Lokar’s XL size POWER brake pad has an outside meas. Of

6” x 2 3/4” & fits the 3 1/4” x 1 5/8” original steel brake pedal. For ‘55, ‘56 & ‘57.

Eliminator Floor Mount Gas Pedal

Pedal eliminates routing cables through firewall and comes equipped with a billet aluminum splined adjustable shaft and stainless steel “under-the-floor” cable mounting bracket. Mounts in multiple positions for floor and toe board angles. Designed with built-in pedal travel stops. Available in ball-milled billet aluminum pad or with rubber inserts. Requires 36" “U-Cut-to-Fit” Lokar Throttle Cable for most applications. Order 48" cable for LS1 Ramjet and Vortec applications.

If you are looking for a nostalgic style throttle pedal, Lokar has the Spoon. The Lokar Spoon Throttle Pedal is designed with the same quality as shown in Lokar’s other throttle assemblies. Removable lower arm is splined for versatility in mounting to the right or left of the mounting bracket.

Aluminum Throttle Pedal Spacers

Is your throttle pedal buried in your carpet? Lokar has designed a spacer just to eliminate that dilemma. We offer a billet aluminum spacer in three styles: One for the standard billet aluminum assemblies, one for the chromed-steel assemblies, and one for our Eliminator Floor Mount Pedal. Spacer mounts directly to the center of the pedal mounting bracket.