©2008-2010 DANNY’S ROD SHOP. ALL RIGHTS RESERVED. ©2008-2010 WEB DESIGN BY DREAMERS GATE / DG WEBS. CONTENT OF THIS SITE MAY NOT BE USED WITHOUT PRIOR AUTHORIZATION FROM THE OWNER. PLEASE REPORT WEB SITE PROBLEMS AND ERRORS TO WEB.SUGGESTIONS@DANNYSHOTRODS.COM.
Danny’s Rod Shop
55 Norwood Road
Somerset, KY 42503
Telephone: 606-423-1969
Fax: 606-423-3522
Toll Free: 800-335-1932
Since 1982
SMALL BLOCK CHEVY
SHORT WATER PUMP - POWER STEERING
SHORT WATER PUMP - POWER STEERING
404L - POWER STEERING PUMP & MOTOR MOUNTING BRACKET - SP - $105.00
ALAN GROVE COMPONENTS specialize in fabricated specialty vehicle components. The mounting brackets are crafted from steel plate with a commitment to quality. All welding is T.I.G. and all edges are smoothly finished. The brackets include all the necessary bolts, nuts, spacers, hardware, belt-length recommendations and "easy to follow" illustrated instructions for simple installation.
400L-POWER STEERING PUMP BRACKET- SP $67.50
This combination front motor mount & power steering pump is designed spec. For 1955-1957 Chevy passenger cars & 1955-1959 trucks. Designed for use with the non-metric Chevy Saginaw power steering pumps with attached reservoir and
short water pump, this bracket allows clearance for the alternator belt no matter where the alternator is mounted. It directly replaces the original driver’s side motor mount bracket & will work with the large 8” balancer. Requires the use of a 1958 or later block with the side motor mount bosses. Nor for use on vehicles that have been converted to side motor mounts.
This bracket is designed for the Chevrolet Saginaw non-metric power steering pump with the attached reservoir. Allows clearance for the alternator belt no matter where the alternator is mounted. These pumps were used on most Chevy
applications with short and long water pumps until the early 1980’s. Short water pump applications are normally driven off an add-on third crankshaft pulley.
This bracket is designed to be used with the Metric GM remote reservoir type 2 pump. Designed for street rod app., it sits high enough to clear most chassis parts & steering gears. Will not work with low profile brackets. Pump is driven off
the outer groove of a 3 groove crank pulley. Pump uses an aluminum V-belt pulley.
409L-POWER STEERING PUMP BRACKET - SP $67.50