Danny’s Rod Shop
55 Norwood Road
Somerset, KY 42503
Telephone: 606-423-1969
Fax: 606-423-3522
Toll Free: 800-335-1932
Since 1982
"Clean Wipe" Wiper Motors
The Clean Wipe windshield wiper drive is a direct bolt in replacement for your original vacuum wiper motor. Clean Wipe drive units are easily installed using the original factory brackets and original wiper transmissions. No modifications are required for installation. Each unit comes complete with nylon bushings to replace the factory rubber bushings in your wiper transmission linkage arm.
PN14200
$66.95
PN14202
$24.15
PN 14201
$29.00
$22.05
PICTURE
AVAILABLE
AT THIS TIME
All motors are 12 VOLT only.
For 6 Volt you must purchase a
6 to 12 VOLT power inverter $149.95
New Port Engineering’s Clean Wipe Wiper Drive is now available for 1962-67 Chevy II Novas. Now you can update your original wiper motor with a new heavy duty, two-speed, self parking motor that is smaller and more powerful than the original or a rebuilt motor. This gives you more room for that aftermarket ignition or big block engine. The kit bolts directly into the stock brackets and connects to the stock wiper transmission linkage arms. Standard features include a two-speed switch and wiring harness. Optional features include an intermittent delay switch, washer pump kit, and a switch conversion kit designed to work with the original knob and bezel. Don’t waste your money on a rebuilt wiper motor, upgrade to a Clean Wipe Wiper Drive from New Port Engineering and improve the drive-ability of your car.
The Clean Wipe Wiper Drive is a true bolt-in replacement for your original equipment vacuum or electric windshield wiper motor. Each model of the Clean Wipe Wiper Drive is designed for the specific year and model of vehicle.
- Wiper drives attach to the stock mounting brackets.
- Designed for attachment to O.E.M. wiper transmission or cable drums.
- Each kit comes complete with nylon bushings to replace the rubber grommets in the wiper transmission linkage arms. (when required)
- Clears Stock Cowl Vent and Air Conditioning
- Three Year Guarantee
This application requires the use of our shaft extension if you intend to mount the switch in the stock location and use the stock knob and bezel. You can add one on the next step.
SHAFT EXTENSION (NEEDED IF MOUNTING THE SWITCH IN STOCK LOCATION AND USING THE STOCK KNOB.
