Danny’s Rod Shop
1843 Old SR 28
Goshen, OH 45122
Tech/Orderline: 513-722-3522
Toll Free: 800-335-1932
Since 1982
©2008 DANNY’S ROD SHOP. ALL RIGHTS RESERVED. ©2008 WEB DESIGN BY DREAMERS GATE / DG WEBS. CONTENT OF THIS SITE MAY NOT BE USED WITHOUT PRIOR AUTHORIZATION FROM THE OWNER. PLEASE REPORT WEB SITE PROBLEMS AND ERRORS TO WEB.SUGGESTIONS@DANNYSHOTRODS.COM.
E-Z DOOR HANDLE INSTALL KITS
The outside installation kit bolts into the door and the shaft of the outside door handle slides through it. Then connect the rods from the handle lever to the latch release lever. The kit is for two doors.
Both are spring loaded to return the handle to the original position. The kit is for 2 doors.
INSIDE
OUTSIDE
These kits make it easier to install door handles when using bearclaw latches. The inside installation kit makes it easier to install inside door handles when using rotary latches. The inside kits are available in ford/Mopar square shank or G.M. to 1948 spline shank.
The Deluxe Hidden Hinge Kit's straight-forward design makes it easy to install compared to others. The hinge pins are a smooth-ground pin, not just a bolt. Self-lubricating brass bushings ensure years of smooth operation, no wear and, as a result, no door sag. The 3/8"-think cold roll steel hinge simply do not flex.Kits come complete with floating nut plate recessed for the doors and hidden switches to operate dome lights, burglar alarms, etc. The hinges are made separately instead of being joined into one piece. This offers the installer flexibility in locating them in the each particular car. These kits come complete with floating nut plate recessed for the doors and hidden switches to operate dome lights, burglar alarms, door-adjustable door stop screws, and hidden switches. Thorough instructions are included with each kit, as well as all mounting hardware.
CAROLINA’S DELUXE HIDDEN HINGE KIT
HH-600 $349.95 EACH
E-Z JUMPER KIT (REMOTE E-Z JUMPER TERMINAL KIT)
Here's a way to ensure safe and sure entry and jump starting when you battery fails. Or to provide easier jump starting access for cars with hard to reach batteries. It's also great for jump starting other cars.
The jumper block is dielectric plastic approximately 1 1/4" X 4". The small size allows installation just about anywhere. The lead terminals are stamped "P" for positive and "N" for negative.
Five feet of cable is included, with terminals crimped on each end. The cable can be cut anywhere within the five foot length and secured in the terminal block, allowing for varying lengths of positive and negative cable.
The jumper block is dielectric plastic approximately 1 1/4" X 4". The small size allows installation just about anywhere. The lead terminals are stamped "P" for positive and "N" for negative.
Five feet of cable is included, with terminals crimped on each end. The cable can be cut anywhere within the five foot length and secured in the terminal block, allowing for varying lengths of positive and negative cable.