Lokar Brackets & Springs

©2008-2010 DANNY’S ROD SHOP. ALL RIGHTS RESERVED. ©2008-2010 WEB DESIGN BY DREAMERS GATE / DG WEBS. CONTENT OF THIS SITE MAY NOT BE USED WITHOUT PRIOR AUTHORIZATION FROM THE OWNER. PLEASE REPORT WEB SITE PROBLEMS AND ERRORS TO WEB.SUGGESTIONS@DANNYSHOTRODS.COM.

Tri-Power Bracket & Springs

TRP-4003: BRACKET WITH SPRINGS

$43.65

Designed for Rochester Tri-Power. Kit includes Stainless Steel Throttle Cable Bracket and Stainless Steel Springs. Stainless bracket mounts under rear carburetor on Rochester 3-2 set-up. Cables operate from center carburetor. Stainless Bracket and Dual Stainless Springs are used to mount Lokar’s Throttle Cable and Kickdown assemblies.

TRP-4004: BRACKET ONLY

$31.52

LT-1 & LT-4 Bracket Kits

TCB-40LT1: THROTTLE & KICKDOWN BRACKET

$57.02

Stainless Throttle and Kickdown Brackets replace factory brackets. Kit includes stainless arm to mount on LT-1 throttle body to operate kickdown. Designed to be used with Lokar’s Tuned-Port Throttle Cables and Tuned-Port Kickdowns.

TCB-40LT4: THROTTLE CABLE / KICKDOWN BRACKET

$57.02

Brackets fit the GM ramjet engine. This bracket along with Lokar's TC-1000LS1 Throttle Cable recommended tune-port kickdown (specify transmission on order form) will allow the ramjet to work properly in any vehicle. When used with an automatic transmission, be sure to use the transmission specific Lokar Kickdown Cable.

Ramjet Bracket

TCB-40RJ: RAMJET BRACKET

$57.02

Ford EFI Bracket fits 1986 to 1993 Ford 302 and 351 electronic fuel injection systems that have installed the Mustang EGR spacer. This Polished Stainless Bracket mounts in stock location for easy installation of our Kickdown Cables and Throttle Cables. (1986 to 1993 uses TC-1000HT)

EFI Bracket

TCB-40EFI: EFI BRACKET

$14.50