SINCE 10/8/2010
Danny’s Rod Shop
55 Norwood Road
Somerset, KY 42503
Telephone: 606-423-1969
Fax: 606-423-3522
Toll Free: 800-335-1932
Since 1982
|
ITEM # |
SIZE |
PRICE |
BUY |
|
670600 |
6" Billet Steel Support Bearing |
$46.88 |
|
|
650000 |
Billet Aluminum Support Bearing |
$45.72 |
|
|
680000 |
Billet Stainless Steel Support Bearing |
$93.77 |
|
|
670000 |
Billet Steel Support Bearing |
$41.02 |
|
|
660000 |
Polished Billet Aluminum Support Bearing |
$63.29 |
|
|
960000 |
Polished Billet Stainless Steel Support Bearing 3/4" |
$111.35 |
|
|
690000 |
Polished Stainless Steel Rod End Bearing |
$98.46 |
|
|
710000 |
Stainless Steel Rod End Bearing |
$80.88 |
|
|
700000 |
Steel Rod End Bearing |
$32.82 |
|
|
720000 |
Polished Stainless Steel Rod End Bearing |
$98.46 |
|
If more than two joints are used in a steering system, a support bearing must be used to prevent “looping” and binding. Use of a vibration reducer and two u-joints will also call for a support bearing to be used. The support must be mounted to the frame, not to a sheet metal section of the body. Sheet metal will not withstand the stresses. The shaft should fit easily through the support with no binding. A system with a double u-joint and a single u-joint has three flex points and will require a support bearing. Note: all support bearings work with round or DD shafting.
All billet supports accommodate a 3/4” shaft. Our standard supports are 2-1/2” tall with two threaded holes in the end for mounting and are available in steel, aluminum, polished aluminum, stainless steel, and polished stainless steel. 6" support is available only in steel and can be cut at any angle for a perfect fit. The 6” steel support has no mounting holes and must be welded in.
Rod end bearings with a 3/4” hole size are commonly used for supports. Rod end bearings are supplied with two jam nuts for mounting. They are available in steel, stainless steel and polished stainless steel.
Note: all support bearings work with round or DD shafting.
